So in this post I will show
you how to change your IP
Step 1- Open the run command.
Step 2- Type
"command" and click ok
This should open the command prompt.
Step 3-Type "ipconfig
/release", and hit "enter"
Step 4-Type "exit"
Step 5-
Right click on
"Networks" and click properties.
You should now see your
different connection.
Click on connections on right side and click properties.
Then click on properties on the bottom of the page.
Double-click
on the "Internet Protocol (TCP/IP)" from the list under the"General"
tab
Click on "Use the
following IP address" under
the "General" tab.
Create
an IP address.(As you wish...But keeping it a little familiar to your
last one is recommended.
Press
"Tab" and it should automatically fill in the "Subnet Mask"
section with default
numbers.
Hit the "Ok" button here.
Hit the "Ok" button again.
You should now be back to
the "Local Area Connection" screen.
Step6- Now go back to TCP/IP
settings.
Step 7-This time select “Obtain
an IP address automatically”. Hit “Ok”
You now have a new IP address.
Important:-
This only changes your dynamic IP address, not your ISP/IP address.
This only changes your dynamic IP address, not your ISP/IP address.
